Yorco BOD Incubator YSI-440 MILN

Most versatile and highly reliable low temperature incubator, to make Biochemical Oxygen Demand determinations and for preservation of vaccines, insulin, lever extracts, chemicals etc. Rapid and accurate temperature change in ramp mode: Due to the finely tuned control technology, temperatures in the Cooled Incubator ICP reach the setpoint value exactly, without any Control fluctuations. A multifunctional fuzzy controller with permanent performance adjustment and integrated self diagnosis system, as well as two high quality platinum temperature sensors Pt 100, ensure absolutely reliable temperature control and the highest process safety and control accuracy in Biotechnology Biology and Medicine

Available in following chamber sizes :-

W x H x D Capacity
505 x 830 x 415 mm 6.0 cu.ft
575 x 875 x 550 mm 10.0 cu.ft
650 x 900 x 580 mm 12.0 cu.ft
455 x 610 x 415 mm 15.0 cu.ft

Product Features

Technical Specification :-

Temperature Range 0oC to 60oC with a display and setting accuracy of 0.1oC. Multiple over temperature protection :- An adjustable over/under temp controller TWW protection class 3.3 (Optional adjustable electronic temperature limiter TWB protection class 2) takes over control in case of failure at a preset temperature. ASF Automatic Safety Function a unique safety function for over–and under temperature automatically following the setpoint in a freely selectable tolerance range. An alarm sound is activated in case of over-under temperature, and the heating function is switched off in case of over temperature, cooling function is switched off in case of under temperature. In addition a mechanical temperature limiter, TB, switches off heating permanently if the maximum permitted oven temperature is exceeded by approx. 10oC.
1 high grade platinum temperature sensors pt 100 in a 3-wire circuit (for Stable long-term transmission of measurement signals) communicate with each other and ensure uninterrupted error-free temperature control at constant working temperature


BOD Incubator YSI-440 MILN with Special Features

Features :-

Lowest Power Consumption Algorithm :- Even though the system has high wattage heater to act in response to any settable temperature more quickly compared to other systems, but only a fraction of the heater wattage is consumed when the set temperature has been achieved saving lot of energy. Soft Start For Heaters :- In built soft start for the heaters prolongs the heater life. Automatic Key Lock Feature :- This feature ensures that no manipulation could be done within the system while operated by an un-authorized person, In Built Battery for Controller Operation, Save 70 Programs, Save 1 Profile of 70 Steps (35 Ramps & Soak). Remote Monitoring, Alarm and Controls :- The system incorporates user friendly feather touch buttons for setting temperature, delay time and process time which could be seen on Seven Segment Display. LED’s indicates the mode of operation. All the process data could be recorded to remote computer via RS232/RS485 or an optional attachment for the printer could be provided.


Available in following chamber sizes :-

Data Retentive Delay and Process Timer :- This feature ensures that the material inside is objected to the set temperature for the set time only, irrespective of any power cuts or voltage fluctuations.
Technical Specifications :- Simultaneous display of all parameters such as temperaturem, weekday, time, fan speed and number of ramp, Visual and acoustic alarm in case of over – under/temperature, Alphanumeric text display, Function signals for stand by operating mode, heating and over/undertemperature, Internal log memory with 1024kb to save temperature and error states, with timestamp to the minute, Chip card log including 1 Memory Card XL with 400MB Memory Capacity, RJ 45 (Ethernet) –Interface and Software to read out the appliance’s internal log memory (Optional), Parallel Printer interface for printout of log date via an external PCL 3-Compatible inkjet printer (Optional), Low/High Voltage Detection & Cut (Optional), Remote Machine Monitoring & Operation using Cell Phone (Optional), In Built Serial Thermal Printer (Text & Graph Mode).